Mine is a 935-TS that I received a several weeks back. Its almost ready to cut chips. I'm just about finished with the external VFD circuits and programming and then I need install and mount the controls. With the VFD driving the motor, I measured 22 RPM at the lowest frequency output to 5381 RPM at 60Hz and is very smooth running. Actually everything works smoothly on this machine. I also tracked the x,y and, z axis dials with a dial indicator the hand dials tracked perfectly. So far I very pleased with it having only owned a lesser bench-top import. I built the stand for it because I'm tall and the mill was a little low for me. I raised it about 6 inches. The attached photo shows the mill before I leveled it. After leveling the top jam nuts are snugged down. Also, I was able to get it level within a little less than a thousand in 12 inches -- that was very tedious to do even with two of us.
I'm looking forward to when everything is setup. I hope all goes well with your new machines too.
I'm looking forward to when everything is setup. I hope all goes well with your new machines too.