- Joined
- Dec 6, 2012
- Messages
- 2,677
I need to make some 5V drive spindles splined/keyed for compound heads and likely a few arbors.
I'm thinking about setting up the hex turret and doing a small production run.
These shanks might also work for end mill holders.
If I do the turret set up it'd be easy to make additional shafts if anyone might be interested.
Am curious if anyone has interest or need.
This is early in the fab process, so don't expect them next week.....
Daryl
MN
I'm thinking about setting up the hex turret and doing a small production run.
These shanks might also work for end mill holders.
If I do the turret set up it'd be easy to make additional shafts if anyone might be interested.
Am curious if anyone has interest or need.
This is early in the fab process, so don't expect them next week.....
Daryl
MN