- Joined
- Feb 23, 2013
- Messages
- 152
Hi All
I said I would post some pics of the Clausing mill after I assembled it, most of it went fairly well .
The only thing that's still a mystery is the top retainer (#641-001)that seats on upper pulley of the spindle.
I press fitted all the parts, for some reason the g rove in the spindle did not reach the point where I could
install the retainer, I assume I will have to take the spindle apart and press fit it together again(not too soon
though).
I also included pics of my SB 10L, which I finished about 5-6 months ago, (waiting to sell my house and move), and then assemble that too.
Once again , thanks for all your help with the Clausing Mill !
Regards.......Raz
I said I would post some pics of the Clausing mill after I assembled it, most of it went fairly well .
The only thing that's still a mystery is the top retainer (#641-001)that seats on upper pulley of the spindle.
I press fitted all the parts, for some reason the g rove in the spindle did not reach the point where I could
install the retainer, I assume I will have to take the spindle apart and press fit it together again(not too soon
though).
I also included pics of my SB 10L, which I finished about 5-6 months ago, (waiting to sell my house and move), and then assemble that too.
Once again , thanks for all your help with the Clausing Mill !
Regards.......Raz