Is a note I just got off the phone with Leeson motor technical support oh my God what a joke that was. They did not understand what hooking up to a drum switch mint all he did was send me a PDF of the wiring layout which I already had...
They sure take your money when you want to buy one though
Total 6 s wiring the motor is seized in the hand drawn image above. Except for I hit the shield P2 which I don't understand I don't know what P2 does. I think it might have something to do with it thermal protection reset. Does anyone have any opinions on this looking at the schematics?
I had thought that I already posted this message but I don't see it so here goes again please forgive me if this is a duplicate.
I was able to get everything running normally switching correctly perfect no problems the problem that I'm having is that I am unable to figure out where to put P2. P 2 to be isolated from P1 correct on the other end of the coil? Maybe I just need to step back and look at it again but if I sealed it and don't use it everything runs perfectly I think he too is for thermal protection reset? Is it a good assumption?
Oh yeah if you look up at that hand drawn pencil schematic I followed that including P1 at the bottom right terminal with L1
No p2 is not connected at all. I blow a breaker if I try it with 8 and 3
and my wires are not color coded. they are marked with T#... I can look up the color code if you wish
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.