Question. The back of the turret has that big padeye thingy sticking out. Looks like a good lift or jacking point.
If I construct a cradle to support and stabilize the head from the table, can the table lift it?
If so, between the rear point being jacked, and the supported from tipping head, being lifted at the table end I should be able to
get the lift required. Lifting this way should keep it aligned as well if the head is cradled properly. When I did this years ago
with my Millrite (a lot smaller) it was difficult to get the turret to level out.
If I construct a cradle to support and stabilize the head from the table, can the table lift it?
If so, between the rear point being jacked, and the supported from tipping head, being lifted at the table end I should be able to
get the lift required. Lifting this way should keep it aligned as well if the head is cradled properly. When I did this years ago
with my Millrite (a lot smaller) it was difficult to get the turret to level out.