- Joined
- Jun 7, 2013
- Messages
- 10,101
benmychree, thanks. Those few sentences were very helpful. I'm not sure if I can recognize the bright line you're speaking of on the cutting edges, but I'll look for it. Very helpful to know that you're using a hard wheel to do the gashing. I knew those K hardness wheels would come in handy for something some day. Always interested in any more tidbits about sharpening you can think of. Thanks again.
What I am refering to is the dulling of the cutting edge where the OD or end and the flank of the tooth meet; it should be a perfectly sharp edge, but when dull that edge wears away or breaks dowm and the sharp edge is not to be seen, instead it can look shiny bright.
I might also mention that I have an air bearing Weldon fixture and also a plain bearing Weldon fixture that I would like to sell.
John