- Joined
- Apr 30, 2012
- Messages
- 2,401
you cannot use mach3 as a dro in any manual mode with steppers, I'm not sure about servo motors if the axis is disabled. but for steppers if mach3 didn't move the motors it has no idea where they are.
manual use would require its own dro or direct reading the hand-wheel dials.
I purchased a hand held pendent on ebay for about $39 and run the machine with the buttons for quick operations
steve
manual use would require its own dro or direct reading the hand-wheel dials.
I purchased a hand held pendent on ebay for about $39 and run the machine with the buttons for quick operations
steve