- Joined
- Dec 22, 2015
- Messages
- 561
I haven't used the new mill in a while so today I decided to just turn it on and check out the new light I installed. It would try to start then kick the relay. I tried several times and got the same thing. It's like the motor is overloaded. I checked the belts and pulleys and they turn freely. I took the belts off and it started easily. Put the belts back on and the same thing. I did get it to start a couple of times and let it run for a while. I think the belts have taken a "set" from sitting but I don't think that should be a problem. I tried different belt tensions too. The weird thing is that everything was left exactly as I used it the last time. So why doesn't it work now.
Any one have any ideas. I checked the voltage at the outlet and there is 121 Volts to each side of the plug (total 240V).
I took a short video but can't figure out how to upload it.
Any one have any ideas. I checked the voltage at the outlet and there is 121 Volts to each side of the plug (total 240V).
I took a short video but can't figure out how to upload it.