- Joined
- Jul 11, 2014
- Messages
- 496
Yep, always.
I just go the latest The Home Shop Machinist in the mail today. There was a small article on a hack for the RF30 Mill Drill. A simple plate device to help keep the head orientation when raising or lowering. So I started. Did I need plans, Drawings or a simple sketch? Noooo! not I. I have it all worked out in my head, all I need right?
Screwed it up. I can save it but how many times do I have to do this before I wise up and sketch it out first? There's been many a project that needed 'Do-Over' because I didn't sketch it out.
Ah well, can-teach-an-old-dog, too old to learn better. Dang!
I just go the latest The Home Shop Machinist in the mail today. There was a small article on a hack for the RF30 Mill Drill. A simple plate device to help keep the head orientation when raising or lowering. So I started. Did I need plans, Drawings or a simple sketch? Noooo! not I. I have it all worked out in my head, all I need right?
Screwed it up. I can save it but how many times do I have to do this before I wise up and sketch it out first? There's been many a project that needed 'Do-Over' because I didn't sketch it out.
Ah well, can-teach-an-old-dog, too old to learn better. Dang!
Last edited: