Starting a project and had to cut a 1.5" round to 3/8" and bore to .801".
Bore is spot on but when I measure the Ø I get .375 and .372 on the opposite side.
I wonder if when I parted it and returned it to the 4J if it did not go in square. I did bump it with a bearing on a holder and felt true.
Any other reasons?
I'm going to take a face cut on a large piece before I redo the part.
Bore is spot on but when I measure the Ø I get .375 and .372 on the opposite side.
I wonder if when I parted it and returned it to the 4J if it did not go in square. I did bump it with a bearing on a holder and felt true.
Any other reasons?
I'm going to take a face cut on a large piece before I redo the part.