- Joined
- May 23, 2017
- Messages
- 64
Hi All,
Getting around to finally setting up my 10k. It was a craigslist purchase. The model number is CL770A - serial number 28226KAR7 with a 4' bed. It has the 16 speed v-belt pulley and a taper attachment. My questions are mounting the countershaft assembly to the table, is there a bolt pattern I can use to drill the holes? It's not mounted in the pic below but I'm looking for the horizontal measurement from lathe legs to countershaft bolt holes.
Also, if anyone else has this lathe, what is the belt length from countershaft to spindle. The previous owner included a 44" belt but I don't know if that's the right size?
Getting around to finally setting up my 10k. It was a craigslist purchase. The model number is CL770A - serial number 28226KAR7 with a 4' bed. It has the 16 speed v-belt pulley and a taper attachment. My questions are mounting the countershaft assembly to the table, is there a bolt pattern I can use to drill the holes? It's not mounted in the pic below but I'm looking for the horizontal measurement from lathe legs to countershaft bolt holes.
Also, if anyone else has this lathe, what is the belt length from countershaft to spindle. The previous owner included a 44" belt but I don't know if that's the right size?
Last edited: