- Joined
- Dec 2, 2016
- Messages
- 234
If all I care about is the normal pitch divided by 2. A single wire gives me a close result but my threads are almost four inches in diameter and I am basing the measurement off the O.D. and a solid works model showing me where my pin sits above the thread.
Anyone know of a setup that utiliizes a 4-5" micrometer and can easily hold wires into place. Some of the theread forms I make need <.02" wires.
Anyone know of a setup that utiliizes a 4-5" micrometer and can easily hold wires into place. Some of the theread forms I make need <.02" wires.