- Joined
- Apr 8, 2013
- Messages
- 1,982
Tiny little project but it works so slick I had to share. I bought a set of tap holders that have a 3/8 inch square socket on one end for use with a ratchet (I guess). I milled a 3/8 drive onto a shaft for power tapping in my mill. I feed the quill down with light pressure so it follows the pitch of the tap and lift the handle when it reaches the depth I need and it stops instantly when the 3/8 drive disengages. Re-engage the drive and turn the mill on in reverse and out comes the tap in a few seconds. I used to be nervous tapping at 100 rpm but I tapped the 1/2 x 20 holes pictured at 1200 rpm. Same speed I drilled them at. Maybe everybody but me already knew about this but it sure sped up my tapping.
![DSC_0190.JPG DSC_0190.JPG](https://www.hobby-machinist.com/data/attachments/272/272528-d6ce6524cee059e5a403e46b355299e2.jpg)
![DSC_0194.JPG DSC_0194.JPG](https://www.hobby-machinist.com/data/attachments/272/272530-a6a341a2b3d9b35b0de59b88b5673534.jpg)
![DSC_0190.JPG DSC_0190.JPG](https://www.hobby-machinist.com/data/attachments/272/272528-d6ce6524cee059e5a403e46b355299e2.jpg)
![DSC_0191.JPG DSC_0191.JPG](https://www.hobby-machinist.com/data/attachments/272/272529-da114d37230150dc860b8605d47c8145.jpg)
![DSC_0194.JPG DSC_0194.JPG](https://www.hobby-machinist.com/data/attachments/272/272530-a6a341a2b3d9b35b0de59b88b5673534.jpg)