I got a vise with a CL purchase that I am going to clean up and try to put back in service. It is filthy!
I am almost complete with disassembling it, and got stuck. I have everything except the bottom two castings separated. It looks like the two drive screw nuts are pressed into the middle casting. The bottom nut is keeping the middle casting and the base from separating (captured). Can anyone confirm that these are pressed in or could then be threaded in or pinned... I just don't want to ruin it more than the wear it already has.
Its a jacob CVS-3 according to the sticker that is almost gone and barely legible.
Any help would be great!
I am almost complete with disassembling it, and got stuck. I have everything except the bottom two castings separated. It looks like the two drive screw nuts are pressed into the middle casting. The bottom nut is keeping the middle casting and the base from separating (captured). Can anyone confirm that these are pressed in or could then be threaded in or pinned... I just don't want to ruin it more than the wear it already has.
Its a jacob CVS-3 according to the sticker that is almost gone and barely legible.
Any help would be great!