backlash

I am having problems correcting the Y axis backlash. PM tech support suggested tightening the split-nut screw and tightening the split-nut mounting bolts. After a lot of trial and error I was able to tighten the split nut screw to the point that it was hard to turn the crank handle. There was...

The mill is ready to make chips - now waiting for the DRO. I notice the X axis feels like it has no backlash at all! However the Y seems pretty sloppy to the feel. Does anybody have any info on how to adjust the backlash on this mill?

I have a manual Sherline mill and recently I have been having a lot of problems whenever the endmill starts to cut past the end of a part. The cutter starts dropping down and digs deeper into the work piece. Sounds like backlash, so I loosen the set screw, raise the motor, push down on the...

Looking for some assistance on adjusting backlash for the Y axis on my PM45 Mill. I had about 10 thousands backlash on my both my X and Y axises. I easily found the set screw for the X axis brass lead screw mount, it was about ready to fall out. Adjusted it a little and now have about 3...