-
Welcome back Guest! Did you know you can mentor other members here at H-M? If not, please check out our Relaunch of Hobby Machinist Mentoring Program!
cross slide
-
T-Slot Cross Slide Project
Just floating an idea here. I've gotten it into my head to try building an extended T-slot cross slide for my Model 200 based on Myford's design. To make building it "easier" I've made the circular compound T slot a two-piece design. I would also like to mount a magnetic encoder under the...- Briney Eye
- Thread
- logan m-dro machine dro model 200 myford t-slot
- Replies: 18
- Forum: LOGAN ENGINEERING CO. & LOGAN WARDS
-
Too Much Sail
So I'm in the process of reconditioning a 1968 Clausing 8520 mill that I picked up a few weeks ago. I remember hearing the saying (in a Dolly Parton-ish context) "That's too much sail for such a small boat." Well, I think I've found the machine tool embodiment right here: This Palmgren...- Briney Eye
- Thread
- clausing 8520 palmgren rotary table tilt
- Replies: 0
- Forum: CLAUSING, COLCHESTER, JOHANSSON & BANTAM
-
Mini Lathe Correct Cross Slide Setup?
Hello All! I just purchased a lightly used Little Machine Shop 7x12 mini lathe, and this is my first post. Thank you in advance for any help sorting out my question/issue below. Could anyone tell me if the PO setup the cross slide correctly? He was turning only pen sized plastic material...- HansWorks
- Thread
- mini lathe mini lathe setup
- Replies: 21
- Forum: A BEGINNER'S FORUM (Learn How To Machine Here!)