-
Welcome back Guest! Did you know you can mentor other members here at H-M? If not, please check out our Relaunch of Hobby Machinist Mentoring Program!
pm #1
-
K
PM #1 crankshaft
Was making good progress on the crankshaft, running true, good fit in the base, etc., until I cut out the filler. There must have been some built-in stresses, as the two shafts are no longer in line. Put between centers there is now about 0.012" runout at each web. The two webs apparently...- kmanuele
- Thread
- pm #1 steam engine
- Replies: 4
- Forum: STATIONARY & LIVE STEAM ENGINES