received my PM932M a couple of weeks ago. got it all set up and had no material to cut LOL. no where around my little town to buy stock. ordered some chunks of 6061 on ebay, took a while to get by USPS. anyway.. my 1st mill, in fact I've never even seen a mill live and in person. I have played a bit with a 1953 South Bend 9A lathe I picked up a while ago but not enough to get good at anything.
this is a power valve adjusting tool for a KTM/Husqvarna motocross bike. seemed like a good 1st project anyway. warning! this tool was not built with precision. I will strive to improve. took me over 3 hours and I still have to do final finish. I did learn a few things though. esp that when you cut away a lot of material the work gets harder and harder to hold in the vise.
this is a power valve adjusting tool for a KTM/Husqvarna motocross bike. seemed like a good 1st project anyway. warning! this tool was not built with precision. I will strive to improve. took me over 3 hours and I still have to do final finish. I did learn a few things though. esp that when you cut away a lot of material the work gets harder and harder to hold in the vise.
Last edited: