I have a couple of arbor supports for a 1H... IIRC, the 1H and 2HL use the same supports... if you can send me the measurements, I'll check and see if they will fit.
From what I have read, the 2HL is identical to a 1H, just with a larger table. I'm not 100% sure about that, though...
I have a couple of arbor supports for a 1H... IIRC, the 1H and 2HL use the same supports... if you can send me the measurements, I'll check and see if they will fit.
From what I have read, the 2HL is identical to a 1H, just with a larger table. I'm not 100% sure about that, though...
I measured these supports... the support rods are 2.875" on a 4" center to center spread... and about 5.75" from the middle of the rods down to the center of the arbor.
One has a ¾" collet, the other has a 1-⅞" collet. Both will have to be cleaned up and the oil sight glass (plastic) replaced.
Just confirmed and they are a match. If you want to take to PM to discuss further we can. Let me know what you would like to do if they are excess to your needs.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.