2HL Table Trip Dogs

[MyLilMule]

The 2HL I just acquired were missing both the left and right hand table trip dogs. I figure I will just make replacements when the time comes.

I am looking for dimensions that I can create a drawing from in Fusion 360.

If you have a similarly sized mill (not sure if the 2H or larger would use the same parts as a 1H or 2HL), could you take a few minutes to sketch up some dimensions? I only have a rough idea of what they look like.

 

[Martin W]

Is this what you are looking for? Or are you talking about the angled stops at the ends of the table?
Cheers
Martin

 

[MyLilMule]

What you have pictured is what I am missing. Thanks for the dimensions!

 

[MyLilMule]

Based on your drawing and some other things I was able to find on the internets, I came up with this drawing. The dimensions you have are a little different.

I also wasn't able to understand what you were indicating in the TOP view. You have one section and 1.129 and another a .908 (almost 1") - I assume that I should have read that as something else.

But how closely do these match up?

 

[Martin W]

Yeah, I don't even know where I got the .908 from??? Your measurements look good. I even sketched the T on the wrong side! I can spend more time this evening to measure it again. I had just worked 12 hours and wasn't really on the ball! The .437 measurement is critical, as it fits very close in the T slot.
Cheers
Martin