- Joined
- Oct 9, 2014
- Messages
- 465
The tool addiction can strike at any time without warning. This time I bought a couple of 3-point micrometers. The well recognized Swedish metrology company CEJ Johansson (now integrated in http://www.hexagonmetrology.se/eng/index.htm ) recently sold a lot of equipment on an Internet auction. I was lucky to get some of it for a reasonable sum.
I immediately measured a cylinder bore, which shall be 48.00 mm. The measurement shows that both the bore and the instrument are within good tolerances, unless both of them have the same error.
I immediately measured a cylinder bore, which shall be 48.00 mm. The measurement shows that both the bore and the instrument are within good tolerances, unless both of them have the same error.