84TLC-2130 stand

[JoatTX]

Anybody know the spacing from the spindle riser to the counter shaft bracket for a MW Powr-Kraft 84TLC-2130?

The stand on my lathe is not the original and I know the bracket is set way to far back as when I ordered a replacement flat belt from Logan it was too short by half.

Already posed the same question over on the Logan group site as well.

Joe

 

[T. J.]

The base of my countershaft stand is butted up against the base of the lathe

 

[JoatTX]

Very nice looking machine.
Looking at mine I have 6 to 8 inches between the riser and the countershaft stand.

Thank you for the response