- Joined
- Nov 14, 2020
- Messages
- 1,794
The comments are funny and I thank you for all of them.
I know the previous owner was a machinist for his lifetime and the machine came out of a still active machine shop.
I am tempted to set it up and try it...as long as the cuts are towards the spindle ( no 1 rule I learned in 1978) it will not effect the spring loaded center. (as a machinist you must have an idea where your cutting forces will go)
I know the previous owner was a machinist for his lifetime and the machine came out of a still active machine shop.
I am tempted to set it up and try it...as long as the cuts are towards the spindle ( no 1 rule I learned in 1978) it will not effect the spring loaded center. (as a machinist you must have an idea where your cutting forces will go)