- Joined
- Apr 30, 2015
- Messages
- 11,333
This took me about a week, amazingly no major goofs. My lathe has been bugging me to do it for a while- good catch-up project for pandemic boy
I used 1" cold rolled for the post instead of the more usual 1-1/4", seems pretty solid to me. That was the only piece I needed to buy.
I'm going to fix the socket head screw with removable Loctite, then use the nut to do the pinching- an open end wrench just slips over
-Mark
Next project: A knurler
I used 1" cold rolled for the post instead of the more usual 1-1/4", seems pretty solid to me. That was the only piece I needed to buy.
I'm going to fix the socket head screw with removable Loctite, then use the nut to do the pinching- an open end wrench just slips over
-Mark
Next project: A knurler
Attachments
Last edited: