- Joined
- Nov 21, 2010
- Messages
- 1,602
Not that I dont know how to measure thread pitches etc. against better judgement I bought a screw pitch micrometer with common pitch anvils.
The anvils are marked far as I can tell. Done everything, two pair of glasses plus the magnifier you wear on your head. Do I have to get a microscope?
I can barely make out the female anvils but the males are impossible. And then I have no clue how they can etch numbers that small. For fun I tried
doing trial and error with the anvils and the results don't match. Anyone know how to match these anvils with a common tpi or whatever?
I thought it would be a cool mic. but theres no way I can see that small. (its got about 12 male and females). should have bought end mills instead.
sam
"all she says is, I aint grown up yet" I know
The anvils are marked far as I can tell. Done everything, two pair of glasses plus the magnifier you wear on your head. Do I have to get a microscope?
I can barely make out the female anvils but the males are impossible. And then I have no clue how they can etch numbers that small. For fun I tried
doing trial and error with the anvils and the results don't match. Anyone know how to match these anvils with a common tpi or whatever?
I thought it would be a cool mic. but theres no way I can see that small. (its got about 12 male and females). should have bought end mills instead.
sam
"all she says is, I aint grown up yet" I know