- Joined
- Feb 2, 2014
- Messages
- 112
Her is my new project:
A vise with good precision I hope?
Started with some steel pieces and lathet them.
The axels is from a car (driveaxels).
Here I put a magnet from an old hard disk to take care of steel particles ...
The clearanse is 0,02 mm, but will be 0,1 mm I think?
I Have so many projects, sit I will work with this from time to time.
And the screw will be selfmade to ?
Some good ideas here?
A vise with good precision I hope?
Started with some steel pieces and lathet them.
The axels is from a car (driveaxels).
Here I put a magnet from an old hard disk to take care of steel particles ...
The clearanse is 0,02 mm, but will be 0,1 mm I think?
I Have so many projects, sit I will work with this from time to time.
And the screw will be selfmade to ?
Some good ideas here?
Last edited by a moderator: