I was able to get an Albrecht 0-1/3 chuck at a good price but have a question. It has no taper and I thought it was a MT0 but it isnt. I am trying to get the corrrect taper for it. On the top of the chuck its marked "30 J1" which leads me to believe its a Jacobs 1 taper.
Does anyone know if I am correct on that? Also not sure what the "30" indicates.
Note I wanted to install this on an 8MM watchmakers lathe so I am also looking for a collet that has an 8MM draw to Jacobs 1.
Any comments are welcome.
Thanks
bob
Does anyone know if I am correct on that? Also not sure what the "30" indicates.
Note I wanted to install this on an 8MM watchmakers lathe so I am also looking for a collet that has an 8MM draw to Jacobs 1.
Any comments are welcome.
Thanks
bob