- Joined
- Oct 21, 2014
- Messages
- 2,156
Ok, have been looking for a Tread mill motor to use and have not had any luck finding an old treadmill around. So at the flea Market yesterday I found a 2.25 hp treadmill motor, for $5. Now I need to find a controller and power supply for it. it is a PMDC motor, 18 amp,
Wanting to use it on a bandsaw, I also have to find a way to put a fan on it as it is an external fan.
I am not one who has done much electronics, I know how to splice wires, and can use a simple volt meter but that is where I have normally stopped. Any suggestions or help would be greatly appreciated.
Ken
Wanting to use it on a bandsaw, I also have to find a way to put a fan on it as it is an external fan.
I am not one who has done much electronics, I know how to splice wires, and can use a simple volt meter but that is where I have normally stopped. Any suggestions or help would be greatly appreciated.
Ken