- Joined
- May 7, 2023
- Messages
- 1,360
Im looking to outfit a new (To me) lathe and was (Am) very please with the Aloris wedge style tool post I got from BG. At the time I purchased this set I had seen and liked the design of the Multifix system, but they were double the cost and kinda felt I was going out on a limb as it were ($125 for the Aloris wedge style) and didn't want to get hosed too hard is what I received was junk.
Now that I'm outfitting another similar size lathe I'm seeing the Multifix on Ali E for less than what I paid for my last set to 3x as much for the same size unit and I'm confused/cautious all over again.
So does anyone have experience with one of these? Om looking at the OXA size or equivelent?
Im looking at this one, but they say it takes proprietart tool holders and Im not sure if this is a good or bad thing.
Spare tool holder.
Now that I'm outfitting another similar size lathe I'm seeing the Multifix on Ali E for less than what I paid for my last set to 3x as much for the same size unit and I'm confused/cautious all over again.
So does anyone have experience with one of these? Om looking at the OXA size or equivelent?
Im looking at this one, but they say it takes proprietart tool holders and Im not sure if this is a good or bad thing.
Spare tool holder.