AXA Tool holder holder

[ivel03]

Spent a bit of time making this today. It's made entirely from scrap/salvage - the larger heavier angle was bed frame angle and the smaller lighter angle was part of a shipping crate. I drilled and riveted on each small piece of angle onto the heavier angle iron. There some room for some more holder angles but i might add other tool holders up there instead. I say i'll take it down at some point and paint it but most likely i'll start using it and not look back!

 

[T Bredehoft]

That's a good looking set of tools, and a good solution to a very common problem. I had a rack, similar, wound up putting my assortment of tools in a drawer, don't remember why...Later... I had problems with the readouts and reaching over the work and/or tailstock for tools..

 

[ivel03]

Thanks for the feedback! All of these were in a drawer - the top drawer of a husky tool box but it's a full width drawer and it seemed like a hassle to open to switch tools.

 

[Radials]

Looks good. I did mine kind of similar but used pins instead.

 

[Jspan]

I like it I did the same but 3D printed my blocks and put on aluminum