- Joined
- May 7, 2014
- Messages
- 776
I'm going to offer that I know this is probably not something I should do, but I want to experiment and play with Fire ;-)
I wish to mount my new plasma Machine Torch 30mm dia round by say 300mm long (OMG- I just went metric! Whoot! )
Mounting will be onto a 4" x 8" long aluminum plate. Since I often wished I could 'tilt' the plasma tip to other angles on my old setup I thought I would make my own inexpensive POC torch holder setup to swap in/out as needed when this need arises.
The problem: Ball/Socket fasteners that lock! I've been surfing up a storm. They must be out there. Thoughts and suggestions welcome! This just seemed like a fun way to go on what I thought would be a quick & flexible solution.
What I want but in the UK and a bit out of reach. Doable thought.
http://www.springfixlinkages.com/en...-joints/lockable-ball-and-socket-joints/r3540
Too small (I think).
http://www.sweetwater.com/store/detail/MM01
rubber ball setup at 1.5" ball.
http://www.rammount.com/part/RAM-200-1U
http://www.rammount.com/part/RAM-202U-153
The Pic:
I wish to mount my new plasma Machine Torch 30mm dia round by say 300mm long (OMG- I just went metric! Whoot! )
Mounting will be onto a 4" x 8" long aluminum plate. Since I often wished I could 'tilt' the plasma tip to other angles on my old setup I thought I would make my own inexpensive POC torch holder setup to swap in/out as needed when this need arises.
The problem: Ball/Socket fasteners that lock! I've been surfing up a storm. They must be out there. Thoughts and suggestions welcome! This just seemed like a fun way to go on what I thought would be a quick & flexible solution.
What I want but in the UK and a bit out of reach. Doable thought.
http://www.springfixlinkages.com/en...-joints/lockable-ball-and-socket-joints/r3540
Too small (I think).
http://www.sweetwater.com/store/detail/MM01
rubber ball setup at 1.5" ball.
http://www.rammount.com/part/RAM-200-1U
http://www.rammount.com/part/RAM-202U-153
The Pic: