Ball Turner #3

[rdean]

Many different ways to do it but I doubt mine will be used enough to cause problems. If it does need some tweaking in the future I can just add a shim at the handle end. When in use the boring bar is pushed back into the holder because of the forces exerted on the cutter.

Thanks Ray

 

[rdean]

I modified my insert holder by milling down the sides to follow the insert profile. I also added a roll pin that goes through the insert and down into the shaft to lock it in place.




I made up these handles for another project.


Thanks for looking
Ray

 

[brino]

I modified my insert holder by milling down the sides to follow the insert profile. I also added a roll pin that goes through the insert and down into the shaft to lock it in place.

Thanks you just answered the question I had not yet asked!

-brino