Bandsaw Tracking Problem

[CrossSlide]

I have a Grizzly G0622 – 4” x 6” Bandsaw. I noticed the tracking was off so I adjusted it according to the manual with it standing in the vertical position. When I adjusted it the blade tracked into place on the top wheel just fine but the blade is tracking off the bottom wheel about 1/8”. It’s cutting just fine but the blade is also not touching the back bearing closest to the bottom wheel.


Is there an adjustment to get the tracking right on the bottom wheel?

 

[chevydyl]

It's actually not supposed to touch the rim edge, if it does over time it will wear that edge off, it should be close but not actually touching it