- Joined
- Feb 18, 2019
- Messages
- 58
I bought a circa 1998 Smithy CB-1220XL ( basically a MI-1220XL) a few years back with almost zero hours on it. (Laugh if you will, but I got it, the bench stand , toolbox, and a bunch of tooling for $500.
Finally getting around to setting il up. But when I looked at the dead center I discovered the point was whacked (see picture).
How do I fix this? Can I fix this?
As always - thanks in advance.
Sent from my iPhone using Tapatalk
Finally getting around to setting il up. But when I looked at the dead center I discovered the point was whacked (see picture).
How do I fix this? Can I fix this?
As always - thanks in advance.
Sent from my iPhone using Tapatalk