- Joined
- Feb 24, 2018
- Messages
- 1,044
Here is a project I working on, its a front door for a 100 hp, 1953 Cyclotherm boiler, the fabrication of the door is complete, the burner nose has to be mounted, the refractory pounded in and Kaowool installed an rigidized inside the outside ring. The door also has a davit arm and a hinge assembly, that will be welded in with the door bolted to the front of the boiler.
The door is 41” in diameter, made out of 3/8” plate, with 16” x 5” x 3/16” stainless steel ring, a 24” ID x 2” x 3/16” and 35” OD x 2” x 3/16” steel rings welded to it. There are (12) 1” bolt holes on a 38-1/4” BC, (8) 1” bolt holes on a 22” BC, and (6) 3/8”-16 mounting studs In a 14” BC.
The refractory work will be done next week and then the door will be painted black, with high-temp paint.
The door is 41” in diameter, made out of 3/8” plate, with 16” x 5” x 3/16” stainless steel ring, a 24” ID x 2” x 3/16” and 35” OD x 2” x 3/16” steel rings welded to it. There are (12) 1” bolt holes on a 38-1/4” BC, (8) 1” bolt holes on a 22” BC, and (6) 3/8”-16 mounting studs In a 14” BC.
The refractory work will be done next week and then the door will be painted black, with high-temp paint.