- Joined
- Mar 19, 2015
- Messages
- 275
been clearing all the junk out at my local club.
was an old small lathe in pces in back that the bed was cracked on as was one the bearing housings.
also lots of bits missing but the tailstock was there its 1mt.
got an idea if after cleaning it if its ok that i make it so i can mount it on the cross slide with small chuck for drilling holes up to 5mm.
thinking can also use it cross drilling rd stock.
what do you reckon, sounds to simple so sure im missing something.
was an old small lathe in pces in back that the bed was cracked on as was one the bearing housings.
also lots of bits missing but the tailstock was there its 1mt.
got an idea if after cleaning it if its ok that i make it so i can mount it on the cross slide with small chuck for drilling holes up to 5mm.
thinking can also use it cross drilling rd stock.
what do you reckon, sounds to simple so sure im missing something.