- Joined
- Apr 9, 2016
- Messages
- 120
Hey all I recently bought a very old Brown & Sharpe ???no. 1 horizontal mill. I don’t have it home yet.
I’m told it’s a Brown &Sharpe 9 or 10 taper.
It doesn’t use a draw bar just the center on the over arm.
Can I use a collet holder on this without an arbor or any short arbor without a draw bar or the over arm?
Would I have to have the spindle drilled for a drawbar for this.
As is, the long arbor is removed with a wedge like a Morse taper
I’m told it’s a Brown &Sharpe 9 or 10 taper.
It doesn’t use a draw bar just the center on the over arm.
Can I use a collet holder on this without an arbor or any short arbor without a draw bar or the over arm?
Would I have to have the spindle drilled for a drawbar for this.
As is, the long arbor is removed with a wedge like a Morse taper