These are a couple of carb cable adjuster I made up, makes syncing the carbs a little easier. The adjusters were from 8mm rod, turned down to 6.37mm mm and threaded 1/4" UNF for 40mm. They were drilled through with a3mm hole for the cable inner and the top section enlarged to 5.5mm to take the cable out, then knurled using a scissor knurler I made years ago.
The aluminium brackets are very small, so very difficult to polish. I may anodise these layer.
I still have to fit a locknut to the adjuster, to stop movement.
The aluminium brackets are very small, so very difficult to polish. I may anodise these layer.
I still have to fit a locknut to the adjuster, to stop movement.
Attachments
-
WIN_20210926_15_31_28_Pro.jpg468 KB · Views: 10
-
WIN_20210926_15_33_35_Pro.jpg1,017.6 KB · Views: 10
-
WIN_20210926_15_37_28_Pro.jpg548.3 KB · Views: 10
-
WIN_20210926_15_37_36_Pro.jpg578.6 KB · Views: 9
-
adjuster.jpg45 KB · Views: 9
-
adjuster outlet end.jpg55.4 KB · Views: 8
-
knurler.jpg182.8 KB · Views: 9