- Joined
- Jul 28, 2017
- Messages
- 2,399
Once I learned the trick of using one of the vise mount points as a pivot point for tramming, it takes me a less than minute to tram the vise to .001" or better. It takes longer to do the setup than to perform the tram procedure.
I'm not a fan of alignment pins on the bottom of the vise because I often have to relocate the vise in order to accommodate different sizes of material. One of the disadvantages of owning a small mill.
I'm not a fan of alignment pins on the bottom of the vise because I often have to relocate the vise in order to accommodate different sizes of material. One of the disadvantages of owning a small mill.