- Joined
- Feb 23, 2013
- Messages
- 152
Good Morning to all,
I have a Clausing vert Mill #8525(diff vs 8520 is quill size) which I bought many years ago. I decided
to dismantle, clean and paint it. I finished the entire lower section(have not worked on the head yet).
In putting it back together I noticed the right ball crank handle turns smooth but the dial indicator does
not turn with it? The housing(#386-006) on the left is different than the housing on the right(#386-011),
however the housing on the right is STAMPED with part #386-006 yet it differs from the housing on the
left??.When I switch the ball crank handle and the dial indictor to the left side the dial indicator turns with
the handle appropriately .
The housing on the left side is motorized(which was replaced by a motor and no handle-the way I bought it).
I'm thinking of switching the right side housing with the left side housing and vice versa.
Does anyone have any thoughts on this(before I remove them)
Thanks for your help............Raz
I have a Clausing vert Mill #8525(diff vs 8520 is quill size) which I bought many years ago. I decided
to dismantle, clean and paint it. I finished the entire lower section(have not worked on the head yet).
In putting it back together I noticed the right ball crank handle turns smooth but the dial indicator does
not turn with it? The housing(#386-006) on the left is different than the housing on the right(#386-011),
however the housing on the right is STAMPED with part #386-006 yet it differs from the housing on the
left??.When I switch the ball crank handle and the dial indictor to the left side the dial indicator turns with
the handle appropriately .
The housing on the left side is motorized(which was replaced by a motor and no handle-the way I bought it).
I'm thinking of switching the right side housing with the left side housing and vice versa.
Does anyone have any thoughts on this(before I remove them)
Thanks for your help............Raz