- Joined
- Mar 19, 2011
- Messages
- 940
Hi, there.
A real newbie question: After I bandsaw a piece of steel or aluminum to rough shape, what is the better way to smooth and square it up: Hold the cut surface vertical and use a face mill, or horizontally, and use an end mill cutting on the side? Or is there something better?
I could swear I saw a youtube video about this, but I was looking for something else at the time, and didn't watch it. I haven't been able to find it, since.
Thanks,
Mike
A real newbie question: After I bandsaw a piece of steel or aluminum to rough shape, what is the better way to smooth and square it up: Hold the cut surface vertical and use a face mill, or horizontally, and use an end mill cutting on the side? Or is there something better?
I could swear I saw a youtube video about this, but I was looking for something else at the time, and didn't watch it. I haven't been able to find it, since.
Thanks,
Mike