- Joined
- Aug 29, 2016
- Messages
- 121
A HSB57 controller came with the closed loop stepper I purchased for my Electronic Lead Screw (ELS). It has an option for FOC or PM with the default set to FOC. Does anyone have any experience with which is best?
This controller shuts down if the stepper starts to miss counts. It has happened when I accidentally hit something with the cutting bit while feeding. I have to turn off the lathe for 2 minutes for the controller to reset. Is this normal?
This manual is also used for the HBS57
This controller shuts down if the stepper starts to miss counts. It has happened when I accidentally hit something with the cutting bit while feeding. I have to turn off the lathe for 2 minutes for the controller to reset. Is this normal?
This manual is also used for the HBS57
Attachments
Last edited: