- Joined
- Feb 1, 2015
- Messages
- 9,688
For cutting threads, I made a tool to set the 29.5º angle. Setup is less than a minute, including unfastening/refastening the six compound clamps.
www.hobby-machinist.com
![www.hobby-machinist.com](https://www.hobby-machinist.com/styles/default/xenforo/HMLogo.png)
29.5 Deg. Angle Tool For Lathe
A 29.5 degree angle is most likely the most used angle set on the compound on a lathe. The Grizzly G0602 lathe has a difficult to read dial with 2-1/2 degree graduations. My solution was to make a gage that would provide easy and accurate setting of this important angle. I made mine from a...
![www.hobby-machinist.com](https://www.hobby-machinist.com/styles/default/xenforo/HMLogo.png)