Hi guys,
i recently purchased an older (white powder coated) lathe with some unexpected problems. Specifically, the motor appears to be intermittent.
Im going to crack open the control box to make sure there isn't any specific loose wires etc but is this well known controller board problem I should simply replace?
i have a few things I have to order from LMS (gear cover; a longitudinal feed knurled handle; tool post detent) so would be helpful to get some feedback.
Any advice is appreciated.
Thanks
doug
the three photos show the board, the error state and the running state. Nothing on the board looks obviously BO'd, but electrolytics can dry up, leak etc.
i recently purchased an older (white powder coated) lathe with some unexpected problems. Specifically, the motor appears to be intermittent.
Im going to crack open the control box to make sure there isn't any specific loose wires etc but is this well known controller board problem I should simply replace?
i have a few things I have to order from LMS (gear cover; a longitudinal feed knurled handle; tool post detent) so would be helpful to get some feedback.
Any advice is appreciated.
Thanks
doug
the three photos show the board, the error state and the running state. Nothing on the board looks obviously BO'd, but electrolytics can dry up, leak etc.
Last edited: