- Joined
- Jul 30, 2015
- Messages
- 18
I recently got a Burke Millrite MV and it came with some extras but only came with one collet. The manual says it takes a #9 long taper B&S but the collet that was in it says Hardinge 9B. They look the same from what I can find to look at, but I don't want to buy some and not be able to use them. I contacted Hardinge and they will make 9Bs at almost $200.00 a pop. I found an 11 piece set of B&S (prob made in china) for $160.00.
Does anyone know if these worked in the same holder? The Hardinge seems to be a 1/2-13 thread. Is the B&S the same? All dimensions seem to work so I am hoping someone just used the Hardinge because it was what they had and I can buy the cheaper set to do what little I will need to use it.
Also, If anyone has a set of either of these and would like to deal, let me know. Thanks in advance for the help.
James
Does anyone know if these worked in the same holder? The Hardinge seems to be a 1/2-13 thread. Is the B&S the same? All dimensions seem to work so I am hoping someone just used the Hardinge because it was what they had and I can buy the cheaper set to do what little I will need to use it.
Also, If anyone has a set of either of these and would like to deal, let me know. Thanks in advance for the help.
James