Does anyone have an Extra Logan 2° to MT3 spindle adapter?

[Bartonius]

As the title says, I'm wondering if anyone out there has the Logan Spindle Taper Adapter (for turning between Centers) 2° Outside MT3 Inside.

I tried to cut my own, but there is more runout than I would like depending on how it is clocked when installed.

Reply or PM

Thanks!!

 

[Jimsehr]

As the title says, I'm wondering if anyone out there has the Logan Spindle Taper Adapter (for turning between Centers) 2° Outside MT3 Inside.

I tried to cut my own, but there is more runout than I would like depending on how it is clocked when installed.

Reply or PM

Thanks!!

I would just put a piece of stock in the collet or chuck and turn a center on it in place then it will be dead true.
jimsehr

 

[Bartonius]

I would just put a piece of stock in the collet or chuck and turn a center on it in place then it will be dead true.
jimsehr

That's what I do now, I am trying to get to where I can use a drive/face plate with a dead center.

Skim cutting every time is annoying.

Also it saves alot on set-up time just being able to put the center in the spindle and know it is true.

This is mostly a wish list item.