- Joined
- Dec 6, 2012
- Messages
- 2,677
It seemed like a nice day for a casual drive (with my trailer).
Stopped for coffee at the gas station.
When I came out I learned somebody dumped this thing on my trailer.
What was I to do? It was far to heavy to unload without an engine lift.
I really wish people wouldn't litter.
.... my wife wouldn't believe me either.
Whipp 16 inch shaper, table is clean, gears show no wear at all. One bit holder, no cranks.
Should be an easy process to make her run.
Learning to make her run. That's a different timeline.
$125
I expect that within two weeks my Cincy Toolmaster vertical mill will be operational. Work has been getting in the way of turning new gears and pulleys.
The Peerless 6inch power hacksaw is next.
Followed by the Whipp.
Got a line on a Hardinge Horizontal Mill.
Hmmmm. Call my shop the "island of misfit toys".
Daryl
MN
Stopped for coffee at the gas station.
When I came out I learned somebody dumped this thing on my trailer.
What was I to do? It was far to heavy to unload without an engine lift.
I really wish people wouldn't litter.
.... my wife wouldn't believe me either.
Whipp 16 inch shaper, table is clean, gears show no wear at all. One bit holder, no cranks.
Should be an easy process to make her run.
Learning to make her run. That's a different timeline.
$125
I expect that within two weeks my Cincy Toolmaster vertical mill will be operational. Work has been getting in the way of turning new gears and pulleys.
The Peerless 6inch power hacksaw is next.
Followed by the Whipp.
Got a line on a Hardinge Horizontal Mill.
Hmmmm. Call my shop the "island of misfit toys".
Daryl
MN
Last edited by a moderator: