- Joined
- Dec 1, 2015
- Messages
- 5
I'm in the process of rebuilding a nice older 20" Taiwanese drill press that I bought on Craigslist. Last night I just noticed that there is no hole in the center of the table. I'm thinking I would like to have a hole in the center for convenience of drilling through holes otherwise everything will have to fit in a vise. Currently the table is in perfect shape and I don't want to do this if there are unforeseen downsides.
So I'm here looking for some expert advice. Does this kind of table have a special purpose? If it is just so the cooling fluid runs to the corner drain hole? I could easily add a second catch under the center hole, I think. Anyway, looking for input.
Thanks,
Ray
Oceanside, CA
So I'm here looking for some expert advice. Does this kind of table have a special purpose? If it is just so the cooling fluid runs to the corner drain hole? I could easily add a second catch under the center hole, I think. Anyway, looking for input.
Thanks,
Ray
Oceanside, CA