I did some measuring on MOTOR 2, the 3 phase motor. These seemed more encouraging. All wires to the chassis were in the Mega ohm range resistance measurements for delta wiring. 3,5,9 to 1,6,7 - 5.1 ohms 3,5,9 to 2,4,8 - 5.3 ohms 1,6,7 to 2,4,8 - 5.3 ohms resistance measurements for Y wiring 3,9 to 2,8 - 10.8 ohms 3,9 to 1,7 - 10.5 ohms 2,8 to 1,7 - 10.5 ohms just for giggles I measures from 4,5,6 to the three legs and they all measured 7 ohms. i am "pretty sure" I ran it delta when it was pulling too much current. Should I try it Y?