- Joined
- Dec 27, 2014
- Messages
- 658
I have some taps and tap handles that are not center drilled.
So far I have just used them more or less free hand with good aim.
I don't actually have a taping guide, I use either a center on the lathe, or put the tap in the drill chuck on the mill.
Been meaning to make a taping guide.
I had an idea you are welcome to steal. I was thinking to make a little sleeve that would go over the guide and have a cup on the other end. Seems a pretty simple idea, I am sure it has been done by others already.
So far I have just used them more or less free hand with good aim.
I don't actually have a taping guide, I use either a center on the lathe, or put the tap in the drill chuck on the mill.
Been meaning to make a taping guide.
I had an idea you are welcome to steal. I was thinking to make a little sleeve that would go over the guide and have a cup on the other end. Seems a pretty simple idea, I am sure it has been done by others already.